Will this fit a Hayward Super Pump model #C48L2N134B1, 1 1/2 HP, Volts 115/230?
Reply
I broke the black dial on the"terminal board w/voltage switch. Is ther a way to eliminate board and hard wire @ 230 volts?
Reply
Tom, There is a way to wire the motor with out the terminal board, but I will recommend consulting with a license electrician or replace the Terminal Board Assy W/voltage Switch (628401-001).
Reply
When i run the pump without the pool cleaner, it runs about 5 min and shuts off
Comes back on in about 3 min . Doesint do this with cleaner and motor doesint seem that hot
Reply
Vic, Not sure what's going on, usually it will be the other way around because when the cleaner is working it can put extra load on the motor. Do think replacing the Terminal Board Assy W/voltage Switch (628401-001) will solve your problem but you can give it a try.
Reply
Will this switch fit an AO Smith motor Model # K48L2N100A2
Reply
Hi Ed, This Terminal Board Assy can be used with the K48L2N100A2 motor.
Reply
Does this board have 2 round connectors and 1 spade terminal? How do the 2 round connectors pull apart?
Thanks
Reply
Hello Stan, you can call a tech a A.O smith 866-887-5216 to walk you through any kind of connectors/pull apart.
Reply
Is this equivalent to part number 2518570-001 on a QC 1102 pump motor? Will it work at 208 volts?
Reply
Hi, Joseph. This Terminal Board can be used with the QC1102 motor.
Reply
Is this the correct terminal board replacement for the A.O. Smith Model C48L2N134B1?
Reply
Hi, Frank. Yes, this Terminal Board Assy W/voltage Switch - 628401-001 can be used with the C48L2N134B1 motor.
Reply
Can this be used on motor C48L2EC1103? It is for a Sta-rite 1 1/2 hp irrigation pump.
Reply
Hi, Al. In order to confirm we will need a photo of the motor's existing terminal board.
Reply
Can this terminal board be used on ust1102 motor ?
Reply
Cook, The terminal boards on motors change over time. Please be sure to match your terminal board wit the photos on the page.
Reply
How can I get a new backplate (aluminum casting that holds the bearing and this terminal board? My pump is a WF-26 with a y56y frame. The pump got droped and is othersie ok, but his casting cracked :(
Reply
Hi, Terry. Some parts are listed on the A.O. Smith Motor Parts page. If it's not listed, you will need to provide us with the motor part number.
Reply
I removed the capacitor/switch cover to discover the terminal board w/voltage switch was broken and crumbling. How are the motor leads disconnected and reconnected to the back of the new rotary switch (black rotor)?
Reply
Hi, Dave. We will need to know the motor's Part, Cat or Model number in order to locate the wiring diagram.
Reply
