Part # 7235
Dimensions 6.5" L x 3.75" W x 4.75" D
Alternate Part #'s 25830-704-000
Constructed of the same tough CPVC material used on the NeverLube. Our Check Valve’s clear lid and red seal plate let you easily see and access debris. It features a unique swing/spring design for both return and intake water. The diverter swings completely open with minimal back pressure and no water turbulence.
Hello, I need to replace check valve which has 7236 on the cover. The current valve has a 2" 90deg male fitting on top (looks to be the inlet side according to arrow) and the bottom has 1-1/2" pipe coming out of it. Question is, what is the correct replacement part number for the whole valve? Thanks.
Hello John. The Check Valve part number 7235 is the correct check valve replacement. The check valve in your photo has been attached (over its outside) to a 90 degree 2" PVC Schedule 40 elbow fitting (separate fitting/part) (attached to a diverter valve on the other end) and a 1 1/2" PVC Schedule 40 pipe (inside attachment) on the opposite end. The check valve 7235 can be attached 2" fitting on the outside, 1 1/2" pipe on the inside. Check Valve If there are no plumbing leaks you may wish to consider replacing just the cover assembly. Cover Assembly
Why does the spring in this valve last at best two seasons?
Good afternoon Kevin, The longevity of these springs all depends on the amount of usage they have and whether they are used properly when switching from position to position. Also if your pool has high chemical reads of PH and other chemicals it can cause these parts to wear down prematurely as well.
The flapper on my Jandy Check valve is damaged. Can I replace just the flapper. Is that part for sale if I get a part number?
My check valve is P/N 7236 REV . Pool is 6 1/2 years old. Is 7235 the same as my part? Also can I just replace the flapper and cover without removing entire black pvc fitting?My spa water is draining back into pool whenever pump is not on. I'm assuming it's one of my 2 check valves.
Yes, this will work.
Less than 1 hr
Sawsall and glue
When I bought this house the pool was already here. The original heater was junk so I replaced it with a 175,000 but Raypak. It lasted maybe seven years and then the heat exchanger leaked. Next heater was a Raypak 206,000 btu and it didn't even last four years!! I finally discovered the issue. The original owners didn't have a one-way check valve installed between the heater output and the inline clorinator. I read that these Jandy valves are heavy-duty so I bought one. In five minutes I installed it. Cut the piper and glue it in. Make sure the arrow goes with the flow of water throughout the clorinator. Done. The heater should now last forever!!
(5 out of 5 stars) Great item
Reviewed By: William P L. from Gretna, LA ()
Pros: See inside, can be opened to clean
Purchased to replace a cheap check valve which had broken. The clear top so you can see what is going on inside, and ability to open and clean is a phenomenal improvement. I also think it gets better flow though the valve when open. We will see how it lasts, but seems interior components can be replaced, so should be good long term fix.
(5 out of 5 stars) Jandy check valve is great
Reviewed By: Darian T. from Sarasota, FL ()
Pros: Sturdy construction
Cons: Don't know one yet
I installed this valve between the chlorinator and the heater after learning that it was essential to do so to prevent mechanical failure. I looked at a variety of check valves; yes, the Jandy is a bit more expensive, but the construction is very durable and it works like a charm. You don't want this thing to fail! It's smaller than it looks on pictures online; get the measurements to ensure that you can retro fit it if you've already plumbed. Note also that it comes 180 and 90 degree, if you need a joint application
(4 out of 5 stars) well made pool check valve
Reviewed By: Vita D. from East Stroudsburg, PA ()
Pros: WELL MADE
Cons: NONE SO FAR
THIS IS MY 3RD CHECK VALVE AND NONE HAVE LASTED MORE THAN TWO SEASONS. THIS CHECK VALVE APPEARS TO BE HEAVIER DUTY THAN ANY I HAVE PURCHASED BEFORE. NOW IT JUST HAS TO WITHSTAND THE TEST OF TIME.