Part # 5270-95
Manufacturer Code SCN-435-36
Alternate Part #'s 35-125-2173, 601319, SCN-435-36, SCN43536
Rotating Switch Single Speed
Apparently, I removed the dip switch while reinstalling my variable speed motor. 2 of the long legs have broken off. Can the switch be replaced? What are the odds I screwed up the circuit board? I just had the bearings replaced and would like to use the motor even if it just runs at full speed, like it normally does anyway.
Do you sell the dip switch?
Does it install easily?
Reply
Good morning Rich, Without the make and model I do not know the correct part you need is this the part you are talking about?Rotating Switch (scn-435-36) . My best advice is to reach out to the manufacturer of the motor if it is A. O. Smith Water Products Company/Technical support1-800-527-1953. If not you can let us know the make and model and if we don't carry it. We can point you in the right direction.
Reply
ran over the cord for my pool pump with the lawn mower while the pump was running.It shorted out the wiring , tripped the breaker in the panel. I replaced the cord and rest the breaker. when I turned the pump back on ,it hummed and would not rotate. I gave it a spin it ran. The pump is a Hayward power flow matrix the motor is a 1.5 hp
Century SPX1515Z1E .It look like there is no start capacitor, are there parts that i can change on motor that will get it to start spinning on start up.
Reply
Hi, David. The issue could be this Rotating Switch - SCN-435-36 or the Switch, Stationary - SCN-486 not making contact.
Reply
I WANT TO THANK YOU SO MUCH .I OPENED BACK OF MOTOR, THE ROTATING SWITCH WAS STUCK I GOT IT TO MOVE AND IT WORKED PERFECTLY .YOU THE MAN !!!!!
Reply
The Most Recent Reviews
(4 out of 5 stars) Rotating Switch
Reviewed By: Philip M. ()
Correct part fit nicely repaired issue I had with motor, would be nice if part included schematic break down of motor
Was this review helpful to you?