By Zodiac
Part # 6203-071B
Manufacturer Code R0011700
Alternate Part #'s E0096100, R0011700, R0099700, 47-295-1412, JDYR0011700, JNDR0011700, LAR-151-5185
. CONNECTOR) . ON THE BACK OF THE HONEYWELL CIRCUIT BOARD CURRENT VERSION HAS 5 (4 WERE REPLACED BY A RIBBON FITS ES, ESII, EPS, EPC-II, LLD TELEDYNE LAARS COMPLETE TEMPERATURE CONTROL ASSY. ORIGINAL VERSION HAD A TOTAL OF 9 SPADE CONNECTORS ..... SPECIAL ..... INCLUDES DUAL CONTROL, HAS KNOBS FOR BOTH POOL & SPA (1) PLATE WITH LABEL & GASKET (2) 6203-072 KNOB (1) 6203-074 KNOB TO SWITCH SPA-OFF-POOL SETTINGS (2) 6203-073 TEMP LOCK (1) CIRUIT BOARD With ALL SWITCHES & POTENTIOMETERS (1) 6203-061 TEMP SENSOR WITH GASKET & PROTECTOR ..... DOES NOT INCLUDE SCREWS TO MOUNT THE PLATE TO THE HEATER JACKET FITS ELECTRONIC IGNITION MODELS BOTH NATURAL GAS AND LP (PROPANE) . (9 TOTAL SPADE CONNECTORS ON BACK OF BOARD) COMPLETE WIRING HARNESS FOR TEMP CONTROL
I have a Laars Lite 2, Model LG LP Gas pool heater which is approximately 87 or 8 years old. Our pool service company says it needs a temperature control assembly - LG to operate safely. Will this particular Temp. Control Assy., Eps (r0011700 substitute for my heater?
Reply
Hi Jay, Here is the correct Temperature Control Assembly for the Laars Lite LG Series Heater.
Reply
What's the difference in these two parts
6203-071B and 6203-071D? These are the numbers on the back of my part I was told that need replacing LAARS E01174-02
L8005 D 1005
Reply
Hi DJ, The difference is which heater the control works on, the 6203-071B works on the Laars ES, ESII, EPS, EPC-II, and LLD models of heaters. The 6203-071D works on the Laars EG, EPG, ESG, LLG and EPM model of heaters. You should be able to pull one of these model #'s off of your heater.
Reply
I have a Teledyne Lars Model EPC-II heater. Is this part a direct replacement for the Temperature Control unit?
Reply
Hi, Dennis. Yes, this Temp. Control Assy - R0011700 is the correct part for the EPC-II.
Reply
i have a teledyne laars series 1 jacuzzi heater. it has a tendency to initially light up and work at first try then goes on for long periods where only gas odor comes out but wont re-light unless we turn it off and restart the unit. what could the problem be? the igniter maybe and if so which part no? thanks in advance
Reply
It is probably the igniter but typically they either work or not. It could be a ground problem check your ground wires and make sure they are clean and have a good connection.
Reply
