Part # 3260-105
Manufacturer Code PSR200
Dimensions 1-1/4" L x 1-3/16" W x 1" D
Alternate Part #'s PSR-200, SPX2700SA, 35-426-1560, APCUS200, USSPS200
Pump Shaft Seal 5/8" - REPLACES HAYWARD - SPX2700SA
Is SPX2700SA OK to use with saltwater pools? If not, , is there a shaft seal for saltwater pools for the Max Flo-II?
Hi, do you send in Switzerland ? & how much does it cost for the shipping ?
Yes we do ship to Switzerland, to get a freight quote you would place the order through the shopping cart our international team will reach back out to with a freight quote which you can either except or deny.
Less than 1 hr
I popped the seal out of the casing then without touching the porcelain part of the seal I lubricated the rubber ring on the seal. Then using the part of the seal that has the grafite end I very carefully and slowly popped the new seal in.
1 to 2 hrs
Screwdriver, Nut Drivers, Socket Set
4 to 8 hrs
Screwdriver, Socket Set
Took a pic of old motor, sent it to INYO....they found the proper replacement and so I ordered it...they suggested that I would need a seal kit and o-ring to do the job correctly...and that was great, so I purchased those also...
They sent the three items with explicit instructions on what to do...great...only one problem...the seal kit said not to touch it as the oil from your fingers could damage the seal...great.....then it said I needed a “water based lubricant to install and lube the seals properly!
I do “a lot” of “ fixing”...in fact the pump install was for a buddy....but I don’t and so I asked a few “ fix it” friends if they had a “water based” lubricant...none did...it would have been “great” if INYO had suggested I purchase some when recommending the other add ones...if they carry it...if they don’t...they should!
Would have saved me a trip to town...and I live on an island...and it’s hard to find...ended up at a drug store with a lube...for night time activities....INYO dropped the ball on this one and I hope this note helps another DYI person!