Will a gas heater operate at the low speed of a dual speed motor?
Reply
Probably not - Most gas heater will shut off at low GPM levels (20-40) to keep the heater cores from overheating - 20 for 200 BTUs, 40 for 400 BTUs. Depending on your pool system you might get these GPM levels at the low speed but generally these heaters must be run at the motor's high speed.
Reply
What is the difference between an Electronic and Millivolt ignition?
Reply
The basic answer is that Millivolt is the old style of ignition, using a standing pilot light. While the electronic ignition uses a spark start system like a gas grill. Electronic ignitions are more efficient in gas usage and also are better suited for high wind areas where a pilot light might get extinguished.
Reply
how far does the pool heater have to be from the house - huntington ny
Reply
For U.S. installations, the point from where the flue products exit the heater must be a minimum of 4 ft below, 4 ft horizontally from, or 1 ft above any door, window or gravity inlet into any building. The top surface of the heater shall be at least 3 ft above any forced air inlet, or intake ducts located within 10 ft horizontally
Reply
The dimension please for p-r207a-en-c #26. Thank you
Reply
Here you may view the Dimensions of the Raypak Pool Heater
Reply
what is the BTU rating on the RP2100 would mainly be used to the heat spa
Reply
For the Low Nox RP2100 units we sell 207,000 BTU, 267,000 BTU, and 407,000 BTU.Here is the link to the Raypak Heaters Low Nox units that show the BTU size.To determine what size Heater you need here is a good article to help you out...Sizing Your Pool Heater
Reply
my current heater is 11 year old Haywood 250 NG. my pool is 12x24 in ground mountain pond. roughly 10,000 gallons. would this heater be the right size for me. thank you
Reply
Good day, based on your old heater and specs we would recommend the RP2100 Digital Heater - R266A - Cupro-Nickel - Natural Gas - P-R266A-EN-X #51 as the replacement option.
Reply
Is this suitable for salt system. I live in CA and am required to have low nox
Reply
Hi William, no worries! Per the manufacturer (Page 2), this is fine for use in a saltwater pool when the salt is 6000 ppm or less.
Reply
