Part # 4703-22
Manufacturer Code SPX0714L
Dimensions 5-5/8" ID, 3/16" Cross Section
Alternate Part #'s 5000-4053, O-336, SPX0714L, SPX714L, 90-423-5358, APCO2162, HAYSPX0714L
Cover O-Ring for Hayward SP0714T Valve
Actual Size: 5-5/8" ID, 3/16" Cross Section
This is the Cover O-Ring for the Hayward SP0714T Valve. If you are seeing leaks around the cover of your multiport valve then this cover o-ring is a top culprit. Easy Homeowner Installation!
Frequently Bought with O-rings
Commonly Use On
I have a Hayward Chlorinator with a cover that leaks. Perhaps it needs an O ring. Where is the O ring in the cover? Why would the cover be so difficult to turn?
Hi. If the o-ring has become stretch or swollen from absorbing water it can make the cover hard to remove. I will need to know the model of the Hayward Chlorinator in order to locate the correct lid o-ring.
The 5 3/4 by 5 3/4 is the right size for the o ring between filter and head valve. Am I correct. On the Hayward Sp714t
NEED AN O RING FOR HAYWARD SAND FILTER --IT HOLDS 350 POUNDS OF SAND AND THE MODEL NUMBER IS S270T --PLEASE HELP
Less than 1 hr
Tweezers or plastic knife
Carefully unscrew counterclockwise your existing pump skimmer lid. Use a pair of tweezers and slide the edge of the tweezers under the old O-ring, lift and rotate the lid as you raise the old O-ring out of its groove. Wash the lid with soap and water to remove any and all debris and algae from the O-ring groove. Use a liberal amount of petroleum jelly and wipe it into the O-ring groove. Take your new O-ring and start it into the groove being careful not to stretch it out. Once you get it started, the jelly will squish out of the groove and the O-ring will slide right into place. Wipe of any excess jelly and your good to go.
Less than 1 hr