$49.99

Qty:

By Pentair Pool Products


Details

Top

Part # 4726-1

Manufacturer Code 190058

Dimensions 3.5" L x 2.5" W x 1.25" D

Alternate Part #'s 190058, 190058Z, 53003201, 17-102-2129, PAC-051-2883, PEN190058Z

Product Description

INYO # 4726-1 PENTAIR # 190058

************************************************

DETAILED DESCRIPTION: THIS IS A BOTTOM MOUNT PRESSURE GAUGE, 1/4" NPT. THIS IS STANDARD PRESSURE GAUGE WITH A MOVABLE RING MOUNTED ON THE FRONT. THE RING HAS AN INDICATOR MARK FOR THE START PRESSURE AND THE CLEAN FILTER PRESSURE. WHEN THE FILTER IS CLEAN THE START PRESSURE INDICATOR IS LINED UP WITH THE ACTUAL START PRESSURE. WHEN THE PRESSURE RISES TO THE CLEAN FILTER MARK, IT'S TIME TO CLEAN THE FILTER. THE PRESSURE GOES FROM 0 TO 60 PSI MATERIAL: PLASTIC

************************************************

DIMENSIONS: DIAMETER: 2" - GAUGE ONLY THREADS: 1/4" NPT THREADS (ACTUALLY MEASURE ABOUT 1/2" DIAMETER)

Top

?     Asked on 4/16/2018by Vickie Tracy

Can this pressure gauge be calibrated. When the pump is not running, the gauge reads 11 - 12 psi, when the pump is running it reads slightly over 22 psi. When the water is diverted to the slide, the psi is about 21.5 psi. We recently replaced the lid to the filter and cleaned the cartridges. The filter is about 10 years old. Is it time to replace the gauge?
 Reply

A  Answered on 4/20/2018 by InyoPools Product Specialist Megan C.

The gauge should read 0psi when the pump is powered off, it is time to replace the gauge. 
 Reply


?     Asked on 11/3/2018by Inyo Visitor

if I have water coming out of the pressure valve at the top of my filter tank does that mean the valve is bad or is there another problem
 Reply

A  Answered on 11/6/2018 by InyoPools Product Specialist Lennox H.

Hi. The probability is high that the valve or the gauge is bad. I would recommend that you inspect the valve closely. 
 Reply


Top
Difficulty

Est. Repair Time

Less than 1 hr

Tools Needed

Plummets tape

Broken pressure gauge

Written on 8/12/2023 by Guest

Turn the pump off . Then unscrewed the broken gauge from the pentair filter housing. Using plummers tape on the new gauge, I screwed it into the pentair filter housing. It works great. A five minute fix. Thanks

Were these instructions helpful? 
 

Difficulty

Est. Repair Time

Less than 1 hr

Tools Needed

Adjustable Wrench

Our current gauge was rusty and did not work.

Written on 5/4/2020 by Guest

We used a wrench and took the old gauge off. We took the new one out of the box and put thread tape around the threads. We then hand tightened the gauge to the pump and gave it a little turn with the wrench. Project complete!

Super easy installation!

Were these instructions helpful? 
 

Difficulty

Est. Repair Time

Less than 1 hr

Tools Needed

Adjustable Wrench

Old gauge lens had become cloudy and could not read the psi.

Written on 1/21/2020 by Guest

Unscrewed old gauge. Applied teflon tape to new gauge threads and installed.

Were these instructions helpful? 
 

Top

Review Summary

 (Average 4.38  out of 5 stars)
8 Rating
5 star:
 
(5)
4 star:
 
(2)
3 star:
 
(0)
2 star:
 
(1)
1 star:
 
(0)

The Most Recent Reviews