If the water is still running out of the backwash after putting it on filter does the multiport need a new o ring
Reply
Florence, the spider gasket on your valve likely needs to be replaced. The spider gasket is a spoked gasket within the valve that directs the flow to the correct pipe. Take some time to read this guide How to Replace a Spider Gasket on a Multiport Valve
Reply
Key 7A appears to be the O-ring that I need for my old HY-TEC hot tub with an AquaFlo Model FMH 07-2 pump. HOWEVER, key 7A indicates 5.5" diameter and my old unbroken item is only 5 1/8" diameter [and is 1/8" thick], and is flat on both sides [by design, or from age is unknown]. Can you help me determine what part I need and can you provide it for me? Your help is appreciated.
Reply
Hi Robert, The FMHP Volute O-ring (92200090) will be the correct o-ring you will need for your AquaFlo FMH Pump.
Reply
I just bought this o-ring. the one that came off is bigger by about .5 inches on the diameter and the cross section is about .2 diameter instead of .125 diameter.
the part number on the valve is 262506
Reply
Hi Gary, The Cover O-ring (358) would be the correct o-ring for the Pentair model 262506 valve.
Reply
I am looking for an O-ring for a splash Pak sand filter model #94086675. Is part# 4700-05A $7.99 the correct part?
Reply
Hi James, This o-ring will work with Splash Pak filter valve but not the actual Splash Pak filter tank. The Tank O-ring (47617204R000) is the o-ring that goes between the valve and the filter body if that's that o-ring that you need.
Reply
I've got a Praher tm12a filter valve and need a top cover o-ring.
Can you give me a part number for ordering and/or tell me what my alternative parts are?.
(I've measured the diameter of the threaded top at a little under 6 inches).
Can you help?
Thanks,
Rob.
Reply
Hi Robert, This o-ring is the correct cover o-ring for the TM12-A valve.
Reply
I have a top mount valve on my koi pond filter. It has developed a leak where the valve clamps onto the tank. I see a wedge shaped gasket that sits between the pressure clamp. I have tightened the two bolts all that can go. The leak has gotten so bad that I had to turn the pump off to prevent the pond from draining. I work away from home and I'm gone M-F. I do not see a replacement clamp or gasket in your parts list. I have a picture.
Reply
Do you have the model of your filter?
Reply
I have a triton II sand filter with a side mount multi valve from pentair will it fit
Reply
is this the correct o-ring for a praher tm-12-L valve?
Reply
Yes, 271103 is the correct cover o-ring for the Pentair - Praher TM12
Reply
