By Goldline Controls
Model # AQL2WWPS8
Manufacturer Code AQL2-WW-PS-8
Alternate Part #'s GOLAQL2-WW-PS-8
Wall Mounted Wired Remote - The wired remote requires 4 conductor wire to be run from the equipment pad to the location in the house where the Wall Mounted Wired Remote will be hooked to the wall. You can Add Up to 3 Wired Remotes to your Aqua Logic system. If you are adding the Aqua Logic to an existing pool, the wireless remote may be a better option.
This remote display is compatible with all Pro Logic PS-4/8/16 models and for all Aqua Logic PS-4/8/16 systems running main software r2.00 or higher.
the system seems to work ok except. when it turns off, the system resets the valves to spillover mode. In this mode the spa drains to the pool level. can i change it so it stays in pool mode.
Reply
Hi Jon, when the spa drains down to the pool level when the pump is off this is most often associated with a bad check valve in the plumbing for the spa. Once that is replaced that should eliminate the draining issue.
Reply
How do you set the pool to heat
Reply
Hi, David. If the heater has already been set up within the configuration and setting menu. You would Press the Button that is assigned to the Heater, it will turn it on. You can review the ProLogic PL-PS-8 Operation Manual.
Reply
My wired remote has tag on the board labeled AQL-REMOTE-PS-8. Is the AQL2-WW-PS-8 remote compatible as a replacement wired remote?
Hi, Chuck. This PS-8 Wired Wall Mount - White - AQL2WWPS8 will be compatible only if your main software is r2.00 or higher. To locate the main software enter the diagnostic menu then main software revision. If not you will need to replace the Main PCB - GLX-PCB-PRO.
Reply
is model AQL-WW-PS-8 AND AQL2WWPS8 is same? I need to replace inside home unit which is AQL-WW-PS-8.PLS let me know what item number you have that i can order.
thanks
Reply
Hi, Model no. AQL-WW-PS-8 is an older unit, the AQL2WWPS8 will replace it.
Reply