Part # 011773
Warranty 1 Year (See Pentair Warranty Card)
Manufacturer Code WF-26
Alternate Part #'s PEN011773
The design that unleashed a new era in whisper-quiet operation
WHISPERFLO pump incorporates innovative hydraulic engineering to move water more efficiently and quietly than competitive pumps. Under typical operating conditions, WHISPERFLO pump offers the greatest water flow of any high performance pump—yet with the lowest electrical consumption. To circulate more water in less time and at the lowest cost, choose quiet, reliable, WHISPERFLO pump
WHISPERFLO pump is engineered to provide optimum performance in a complete range of installations, including pool/spa combinations. It operates suction-side, pressure-side, and in-floor cleaning systems, and is compatible with pressure or vacuum systems, sand filters, diatomaceous earth filters, and cartridge filters.
Additional features include:
Click here for more Pentair Pumps
I just finished replacing the shaft seal on my booster pump. As soon as I turned the pump on water was leaking from the shaft seal. Is it defective or am I doing something wrong?
Depending on the model, the installation of a booster pump shaft seal can be slightly different than a pool pump shaft seal. Some booster pump and pool pump shaft seals require that a silicone sealant be used on the outer areas of the metal seat of the shaft seal. The seal will need to be lightly hammered into the body of the pump. You can use a 1 inch PVC coupling or a piece of 1 1/4 inch PVC pipe and a rubber mallet. This procedure will apply to any pool pump or booster pump using a >PS-1000 style shaft seal.
How much energy will this WF-26 Whisperflow pool filter use?
The WF-26 pump uses roughly 1,880 watts, if you run your pump 8 hours per day this equates to roughly 15.04 Killowatt Hours (kWh). The cost per kWh varies greatly based on the state you live in for example California and Hawaii are very expensive. If you take the national average of 13 cents per kWh you would spend $1.95 per day to run this pump 8 hours.
What is the difference between the WFE-26 and WFE-6?
Hi, The Total HP are the difference between the WFE-26 and the WFE-6 pumps. The WFE-26 pump has a total hp of 1.25 and the WFE-6 pump has a total hp of 2.20.
how can I tell if my pump motor or pump has gone bad. when I turn the pump on a puff of smoke came from the rear of the motor and the breaker popped.
Hello, either there is a type of wiring problem, please check with wires are connected properly and not broken or corroded. It could be also since the breaker popped and smoke that something wasn't ground or connected which your motor is possibly compromised.
(5 out of 5 stars) Excellent replacement pump
Reviewed By: Frank from Fort Worth, TX ()
Pros: Easy to install, quiet running, very good circulation
Shipped and received quickly, fit everything perfectly, went in easy as pie, had full instructions, but were not even necessary.