Part # 5111-87
Manufacturer Code SPX1515Z1E
Dimensions 12.5" L x 6.5" W x 6.5" D
Motor 1.5 HP w/ Switch - SPX1515Z1E
Note: NOT California or New York Title 20 Compliant.
*Replace whole pump with a compliant variable speed.
What is Service Factor?
Reply
Service Factor(SF) is a multiplier that when multiplied by the horsepower of the motor indicates the total permissible horsepower loading that may be carried when the motor is operating at rated voltage and frequency. The most important thing to remember when replacing a motor is that the replacement motor's horsepower times its service factor must be equal to or greater than the original motor's horsepower times its service factor. The Service Factor rating can be found on the motor label. See Step 4 of our How to Read a Pool Motor Label guide.
Reply
my pool pump is making a high pitched noise and it getting hot
it is working but very noisy
what could it be that is causing this noise ? the pump is about 12 yrs old 1.5 HP inground pool
Reply
Good afternoon. The high pitch noise is the bearing starting to go. I can not say how long you have before it gives out. It could be a matter of days or weeks. The bearing are starting to stick which in turn causes more heat.
Reply
Does this pump have a toogle switch to turn on or off? i have a pump now that i
have to pull the plug to shut off.
Reply
John- The 1/2 Hp W/ Switch (SPX1515Z1E, SP1515Z1E) part # 5111-87 does come with the switch to turn it on and off.
Reply
The motor on my Hayward SP1510z1 is making a lot of noise and need to replace it. What motor model should I get that would be compatable with the Hayward DE filter SYSTEM.
Reply
Hi Maria, The SPX1510Z1XE motor is the correct replacement compatible with your partial model number.
Reply
$249.76
$199.00
$379.00
The Most Recent Reviews
(5 out of 5 stars)
Reviewed By: Inyo Customer ()
Old motor was extremely hot due to the inner fan disintegrating and the bearings going out. I ordered the replacement motor and seal kit. Once it arrived, I swapped the power cord from the old motor to the new motor and then changed the seal and o-rings then re-installed it to the pump. All is good now.
Was this review helpful to you?