Impeller, 1 HP FR / 1.5 HP UR - C105-137PEB



Part # 5056-09D

By Pentair Pool Products

  5 Average  



Part # 5056-09D

Manufacturer Code C105-137PEB

Dimensions 4.75" X 0.44"

Alternate Part #'s 35-102-1045, 351021045, 40509, 5056-09D, 788379733650, C105-137PE, C105-137PEB, C105137PEB, STA1013705, PENC105-137PEB

Product Description

Impeller, 1 HP Full Rate / 1.5 HP Up Rate - C105-137PEB

Frequently Bought with this Impeller

Shaft Seal for Seal Plate with Copper Cone 5250-100
Shaft Seal for Seal Plate without Copper Cone 5250-104
Diffuser 5056-10C


?     Asked on 8/18/2020by ANGELO CAVALLERO

Looking for impeller for sq1152 pump in-ground pool 1 and a half horse

A  Answered on 8/18/2020 by InyoPools Product Specialist Lennox H.

Hi, Angelo. You will need to provide us with the pump housing model so that we can locate the correct impeller. We're unable to use the motor #.

?     Asked on 4/8/2020by Inyo Visitor

I have purchased the Century 1.0HP USQ1102 replacement motor and figured it would be time to replace the seals for my Sta Rite P2RA5E pump I want to replace propeller while in there what product number would I need? Are there any specific seals I would need to purchase with the propeller? I do not know if it is prior 98 or after 98


A  Answered on 4/8/2020 by InyoPools Product Specialist Hector F.

The part number for the impeller using the USQ1102 motor is 5056-09CA that you can view by clicking here and the seals and gaskets would be the GOKIT54 that you can view by clicking here. Also if you have the pre 98 series then the only thing that you may need to do is remove the copper cone insert in the seal plate where the shaft seal is set. 

?     Asked on 3/30/2019by john

This impeller has no provision for a nut and is a clockwise thread. Sooooo at what torque do I apply to the impeller to ensure it doesn't come loose during operation. Nowhere in you website do you address this type of impeller. It is a pre1998 pump.

A  Answered on 3/30/2019 by InyoPools Product Specialist Lennox H.

Hi, John. That is correct, no impeller screw required and is right hand threads. The impeller is hand tighten on to the motor shaft.

  • Commented on 3/31/2019 by Product Owner

    Thank you for the prompt reply and sound advice. Now I can reassemble my pump for a season of enjoying my redwood hot tub. Thanks again.

?     Asked on 9/26/2014by Guest

I just bought a variable speed motor from you guys and I'm installing it on a Dura Glas pump. It's a 1.65 v-green, variable from 600 to 3450 rpm. What impeller should I be using?

A  Answered on 9/26/2014 by InyoPools Product Specialist Patrick P.

Would recommend using impeller part # C105-137 PEB.


Review Summary

 (Average 5  out of 5 stars)
4 Rating
5 star:
4 star:
3 star:
2 star:
1 star:

The Most Helpful Review

The Most Recent Reviews